Reference Guide

434 | Content Addressable Memory (CAM)
www.dell.com | support.dell.com
Command
History
Usage
Information
You must save the running configuration using the command copy running-config
startup-config after changing the CAM profile from CONFIGURATION mode. CAM profile
changes take effect after the next chassis reboot.
show cam-acl
c
Display the details of the CAM profiles on the chassis and all line cards.
Syntax
show cam-acl
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
The display reflects the settings implemented with the cam-acl command.
Version 8.4.1.0 Added support for l2-switched-pbr microcode.
Version 8.2.1.0
Added support for the ipv4-64k-ipv6
profile.
Version 7.9.1.0 Added support for VRF protocols.
Version 7.5.1.0 Added the l2-ipv4-inacl CAM profile
Version 7.4.2.0 Added the unified-default CAM profile and lag-hash-align microcode
Version 7.4.1.0 Added the lag-hash-mpls microcode
Version 6.5.1.0 Added the eg-default and ipv4-320k CAM profiles
Version 6.3.1.0 Introduced on E-Series
Note: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs.
Note: Do not make any changes to the CAM profile after you change the profile to
ipv4-320K and save the configuration until after you reload the chassis; any changes lead to
unexpected behavior. After you reload the chassis, you may make changes to the IPv4 Flow
partition.
Version 7.8.1.0 Introduced on C-Series