Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 421
Command Modes
CONFIGURATION (conf-ext-community-list)
Command
History
ip extcommunity-list
c e s
Use this feature to enter the Extended Community-list mode.
Syntax
ip extcommunity-list word
To exit from this mode, use the exit command.
Parameters
Defaults
No defaults values or behavior
Command Modes
CONFIGURATION (conf-ext-community-list)
Usage
Information
This new mode will change the prompt. See the example below.
Example
Figure 12-31. Command Example: ip extcommunity-list
Command
History
match extcommunity
c e s
Use this feature to match an extended community in the Route Map mode.
Syntax
match extcommunity {extended community list name}
To change the match, use the no match extcommunity {extended community list name}
command.
Parameters
Defaults
No defaults values or behavior
Command Modes
ROUTE MAP (config-route-map)
Usage
Information
Like standard communities, extended communities can be used in route-map to match the attribute.
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series
word
Enter a community list name (maximum 16 characters).
(conf)#ip extcommunity-list test
(conf-ext-community-list)#
Version 7.8.1.0 Introduced on S-Series
Version 7.7.1.0 Introduced on C-Series
Version 7.6.1.0 Introduced on E-Series
extended community list name
Enter the name of the extended community list.