Reference Guide

42 | File Management
www.dell.com | support.dell.com
Example
show bootvar
c e
Display the variable settings for the E-Series boot parameters.
Syntax
show bootvar
Command Modes
EXEC Privilege
Command
History
Example
Command Output example: show bootvar
Related
Commands
FTOS#show boot system all
Current system image information in the system:
=============================================
Type Boot Type A B
----------------------------------------------------------------
CP DOWNLOAD BOOT invalid invalid
RP1 DOWNLOAD BOOT invalid invalid
RP2 DOWNLOAD BOOT invalid invalid
linecard 0 is not present.
linecard 1 DOWNLOAD BOOT invalid invalid
linecard 2 DOWNLOAD BOOT 4.7.5.387 6.5.1.8
linecard 3 DOWNLOAD BOOT invalid invalid
linecard 4 DOWNLOAD BOOT invalid invalid
linecard 5 is not present.
Peer RPM:
=============================================
Type Boot Type A B
----------------------------------------------------------------
CP DOWNLOAD BOOT invalid invalid
RP1 DOWNLOAD BOOT invalid invalid
RP2 DOWNLOAD BOOT invalid invalid
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
FTOS#show bootvar
PRIMARY IMAGE FILE = ftp://box:password@10.31.1.205//home/5.3.1/5.3.1.0/FTOS-ED-RPM1-5.3.1.0.bin
SECONDARY IMAGE FILE = variable does not exist
DEFAULT IMAGE FILE = flash://FTOS-ED-5.3.1.0.bin
LOCAL CONFIG FILE = variable does not exist
PRIMARY HOST CONFIG FILE = variable does not exist
SECONDARY HOST CONFIG FILE = variable does not exist
PRIMARY NETWORK CONFIG FILE = variable does not exist
SECONDARY NETWORK CONFIG FILE = variable does not exist
CURRENT IMAGE FILE = ftp://box:password@10.31.1.205//home/5.3.1/5.3.1.0/FTOS-ED-RPM1-5.3.1.0.bin
CURRENT CONFIG FILE 1 = flash://startup-config
CURRENT CONFIG FILE 2 = variable does not exist
CONFIG LOAD PREFERENCE = local first
BOOT INTERFACE GATEWAY IP ADDRESS = variable does not exist
FTOS#
boot config Set the location of configuration files on local devices.
boot host Set the location of configuration files from the remote host.