Reference Guide

Border Gateway Protocol IPv4 (BGPv4) | 409
Command
History
redistribute ospf
c e
t
s
Redistribute OSPF routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map
map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
When you enter redistribute ospf process-id command without any other parameters, FTOS
redistributes all OSPF internal routes, external type 1 routes, and external type 2 routes.
This feature is not supported by an RFC.
Command
History
show ip bgp cluster-list
c e
t
s
View BGP neighbors in a specific cluster.
Syntax
show ip bgp ipv4 multicast cluster-list [cluster-id]
Parameters
Command Modes
EXEC
EXEC Privilege
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
process-id
Enter the number of the OSPF process.
Range: 1 to 65535
match external
{
1 | 2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF external routes.
You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal
routes only.
route-map
map-name
(OPTIONAL) Enter the keywords
route-map followed by the name of a configured
Route map.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
cluster-id
(OPTIONAL) Enter the cluster id in dotted decimal format.