Reference Guide

408 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
FTOS
resolves the network address configured by the network command with the routes in the main
routing table to ensure that the networks are reachable via non-BGP routes and non-default routes.
Related
Commands
Command
History
redistribute
c e
t
s
Redistribute routes into BGP.
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static] [route-map
map-name] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
If you do not configure default-metric command, in addition to the redistribute command, or there is no
route map to set the metric, the metric for redistributed static and connected is “0”.
To redistribute the default route (0.0.0.0/0) configure the neighbor default-originate command.
Related
Commands
redistribute Redistribute routes into BGP.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.
static Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).
neighbor default-originate Inject the default route.