Reference Guide

402 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
neighbor default-originate
c e
t
s
Inject the default route to a BGP peer or neighbor.
Syntax
neighbor {ip-address | peer-group-name} default-originate [route-map map-name]
To remove a default route, use the no neighbor {ip-address | peer-group-name}
default-originate command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Command
History
neighbor distribute-list
c e
t
s
Distribute BGP information via an established prefix list.
Syntax
neighbor [ip-address | peer-group-name] distribute-list prefix-list-name [in | out]
To delete a neighbor distribution list, use the no neighbor [ip-address | peer-group-name]
distribute-list prefix-list-name [in | out] command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
Other BGP filtering commands include: neighbor filter-list, ip as-path access-list, and neighbor
route-map.
Related
Commands
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to set the default route of all routers in that peer
group.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of a
configured route map.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to apply the distribute list filter to all routers
in the peer group.
prefix-list-name
Enter the name of an established prefix list.
If the prefix list is not configured, the default is permit (to allow all routes).
in Enter the keyword in to distribute only inbound traffic.
out Enter the keyword out to distribute only outbound traffic.
ip as-path access-list Configure IP AS-Path ACL.