Reference Guide

398 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Command
History
debug ip bgp dampening
c e
t
s
View information on routes being dampened.
Syntax
debug ip bgp ipv4 multicast dampening
To disable debugging, enter no debug ip bgp ipv4 multicast dampening
Parameters
Command Modes
EXEC Privilege
Command
History
debug ip bgp ipv4 multicast soft-reconfiguration
c e s
Enable soft-reconfiguration debugging for IPv4 multicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv4 multicast
soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-address |
peer-group-name] ipv4 multicast soft-reconfiguration command.
Parameters
Defaults
Disabled
Command Modes
EXEC Privilege
Usage
Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv4 multicast routes. If no
neighbor is specified, debug is turned on for all neighbors.
Version 8.4.1.0 Added BGP Soft Reconfiguration support for IPv4 unicast and IPv6 routes
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced
dampening Enter the keyword dampening to clear route flap dampening
information.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
ipv4-address |
ipv6-address
Enter the IP address of the neighbor on which you want to enable
soft-reconfiguration debugging.
peer-group-name
Enter the name of the peer group on which you want to enable soft-reconfiguration
debugging.
ipv4 multicast
Debug soft reconfiguration for IPv4 multicast routes.