Reference Guide

32 | File Management
www.dell.com | support.dell.com
Parameters
Command Modes
EXEC Privilege
Command
History
change bootflash-image
c e
Change boot flash image from which to boot.
Syntax
change bootflash-image {cp | linecard linecard-slot | rp}
Parameters
Defaults
Not configured.
Command Modes
EXEC Privilege
Command
History
Usage
Information
A system message appears stating that the bootflash image has been changed. You must reload the
system before the system can switch to the new bootflash image.
copy
c e s
Copy one file to another location. FTOS supports IPv4 and IPv6 addressing for FTP, TFTP, and SCP
(in the hostip field).
Syntax
copy source-file-url destination-file-url
directory
(OPTONAL) Enter one of the following:
•
flash: (internal Flash) or any sub-directory
•
slot0: (external Flash) or any sub-directory (C-Series and E-Series only)
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
cp Enter the keyword cp to change the bootflash image on the Control
Processor on the RPM.
linecard linecard-slot Enter the keyword linecard followed by the slot number to change the
bootflash image on a specific line card.
C-Series Range: 0-7
E-Series Range: 0 to 13 on the E1200; 0 on 6 on the E600, and 0 to 5 on the
E300.
rp Enter the keyword rp to change the bootflash image on the RPM Route
Processor.
Version 7.5.1.0 Introduced on C-Series
E-Series original Command