Reference Guide

314 | Bidirectional Forwarding Detection (BFD)
www.dell.com | support.dell.com
vrrp bfd
c e
Establish a VRRP BFD session.
Syntax
vrrp bfd {all-neighbors | neighbor ip-address} [interval interval min_rx min_rx multiplier
value role {active | passive}]
Parameters
Defaults
See Parameters.
Command Modes
INTERFACE
Command
History
all-neighbors
Establish BFD sessions with all BFD neighbors on an interface.
neighbor ip-address
Enter the IP address of the BFD neighbor.
interval milliseconds
(OPTIONAL) Enter this keyword to specify non-default BFD session
parameters beginning with the transmission interval.
Range:50-1000
Default:100
min_rx milliseconds
Enter this keyword to specify the minimum rate at which the local system
would like to receive control packets from the remote system.
Range:50-100
Default:100
multiplier
Enter this keyword to specify the number of packets that must be missed in
order to declare a session down.
Range:3-50
Default:3
role [active | passive]
Enter the role that the local system assumes:
• Active—The active system initiates the BFD session. Both systems can
be active for the same session.
• Passive—The passive system does not initiate a session. It only responds
to a request for session initialization from the active system.
Default: Active
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on C-Series
Version 7.5.1.0 Introduced on E-Series