Reference Guide

30 | File Management
www.dell.com | support.dell.com
Related
Commands
boot network
c e
Set the location of the configuration file in a remote network.
Syntax
boot network {primary | secondary} remote-url
Parameters
Defaults
None
Command Modes
CONFIGURATION
Command
History
Usage
Information
To display these changes in the show bootvar command output, you must save the running
configuration to the startup configuration (using the copy command).
Related
Commands
boot system
c e
Tell the system where to access the FTOS image used to boot the system.
Syntax
boot system {rpm0 | rpm1} (default | primary | secondary} file-url
Parameters
show bootvar
Display the variable settings for the E-Series boot parameters.
primary Enter the keywords primary to attempt to load the primary network configuration files.
secondary Enter the keywords secondary to attempt to load the secondary network configuration
files.
remote-url
Enter the following location keywords and information:
• For a file on an FTP server, enter
ftp://user:password@hostip/filepath
• For a file on a TFTP server, enter tftp://hostip/filepath
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
show bootvar
Display the variable settings for the E-Series boot parameters.
rpm0 Enter the keyword rpm0 to configure boot parameters for RPM0.
rpm1 Enter the keyword rpm1 to configure boot parameters for RPM1.
default After entering rpm0 or rpm1, enter the keyword default to specify the parameters to
be used if those specified by
primary or secondary fail. The default location should
always be the internal flash device (flash:), so that you can be sure that a verified image is
available there.
primary After entering rpm0 or rpm1, enter the keyword primary to configure the boot
parameters used in the first attempt to boot
FTOS.