Reference Guide

ACL VLAN Group | 295

ACL VLAN Group

Overview

The ACL VLAN Group feature is available only on the E-Series, as indicated by this symbol under

each command heading: e

Since VLAN ACLs exist as multiple ACLs in the CAM, the size of the ACLs can be limited in the

CAM. The ACL VLAN Group feature permits you to group VLANs and apply ACLs to the group so

that ACLs exist as a single ACL in the CAM.

Commands

The ACL VLAN Group commands are:

• acl-vlan-group

• description

• ip access-group

• member vlan

• show acl-vlan-group

• show config

• show running config acl-vlan-group

See other VLAN commands in Chapter 9, Access Control Lists (ACL).

acl-vlan-group

Create an ACL VLAN group

Syntax

acl-vlan-group {group name}

Parameters

Defaults

No default behavior or values

Command Modes

CONFIGURATION

Note: This feature is supported on IPv4 only and can only be used with the ipv4-egacl-16k

CAM Profile with the acl-group microcode. See Chapter 13, Content Addressable Memory

(CAM).

group name

Specify the name of the ACL VLAN group (maximum 140 characters).