Reference Guide

284 | Access Control Lists (ACL)
www.dell.com | support.dell.com
set origin
c e s
Configure a filter to manipulate the BGP ORIGIN attribute.
Syntax
set origin {igp | egp | incomplete}
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
set tag
c e s
Configure a filter to specify a tag for redistributed routes.
Syntax
set tag tag-value
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
Related
Commands
egp Enter the keyword egp to set routes originating from outside the local AS.
igp Enter the keyword igp to set routes originating within the same AS.
incomplete Enter the keyword incomplete to set routes with incomplete routing information.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
tag-value
Enter a number as the tag.
Range: zero (0) to 4294967295.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
set automatic-tag Compute the tag value of the route.
set level Specify the OSPF area for route redistribution.
set metric Specify the metric value assigned to redistributed routes.
set metric-type Specify the route type assigned to redistributed routes.