Reference Guide

Access Control Lists (ACL) | 283
Command Modes
ROUTE-MAP
Command
History
Related
Commands
set next-hop
c e s
Configure a filter to specify an IP address as the next hop.
Syntax
set next-hop ip-address
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Usage
Information
If the set next-hop command is configured, its configuration takes precedence over the neighbor
next-hop-self command in the ROUTER BGP mode.
If you configure the set next-hop command with the interface’s (either Loopback or physical) IP
address, the software declares the route unreachable.
Related
Commands
Version 8.3.1.0
Implemented
internal keyword
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
set automatic-tag Compute the tag value of the route.
set level Specify the OSPF area for route redistribution.
set metric Specify the metric value assigned to redistributed routes.
set tag Specify the tag assigned to redistributed routes.
ip-address
Specify an IP address in dotted decimal format.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match ip next-hop Redistribute routes that match the next-hop IP address.
neighbor next-hop-self Configure the routers as the next hop for a BGP neighbor.