Reference Guide

274 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Command
History
Related
Commands
match ip route-source
c e s
Configure a filter to match based on the routes advertised by routes specified in IP access lists or IP
prefix lists.
Syntax
match ip route-source {access-list | prefix-list prefix-list-name}
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
Related
Commands
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match interface Redistribute routes that match the next-hop interface.
match ip address Redistribute routes that match an IP address.
match ip route-source Redistribute routes that match routes advertised by other routers.
match metric Redistribute routes that match a specific metric.
match route-type Redistribute routes that match a route type.
match tag Redistribute routes that match a specific tag.
access-list-name
Enter the name of a configured IP access list, up to 140 characters.
prefix-list
prefix-list-name
Enter the keywords prefix-list followed by the name of configured prefix
list, up 10 140 characters.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.8.1.0 Increased name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
match interface Redistribute routes that match the next-hop interface.
match ip address Redistribute routes that match an IP address.
match ip next-hop Redistribute routes that match the next-hop IP address.
match metric Redistribute routes that match a specific metric.
match route-type Redistribute routes that match a route type.
match tag Redistribute routes that match a specific tag.