Reference Guide

Access Control Lists (ACL) | 245
Defaults
Not configured.
Command Modes
CONFIGURATION-EXTENDED-ACCESS-LIST
Command
History
Usage
Information
The monitor option is relevant in the context of the flow-based monitoring feature only. See
Chapter 44, Port Monitoring.
When you use the log option, CP processor logs details about the packets that match. Depending on
how many packets match the log entry and at what rate, the CP may become busy as it has to log these
packets’ details.
The order option is relevant in the context of the Policy QoS feature only. The following applies:
• The seq sequence-number is applicable only in an ACL group.
• The order option works across ACL groups that have been applied on an interface via QoS policy
framework.
• The order option takes precedence over the seq sequence-number.
• If sequence-number is not configured, then rules with the same order value are ordered
according to their configuration order.
vlan vlan-id Enter the keyword vlan followed by the VLAN ID to filter traffic associated
with a specific VLAN.
Range: 1 to 4094, 1-2094 for ExaScale (can used IDs 1-4094)
To filter all VLAN traffic specify VLAN 1.
ip-address
Enter an IP address in dotted decimal format (A.B.C.D) as the target IP
address of the ARP.
opcode code-number Enter the keyword opcode followed by the number of the ARP opcode.
Range: 1 to 16.
count (OPTIONAL) Enter the keyword count to count packets processed by the
filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to have the information
kept in an ACL log file.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the
ACL entry.
Range: 0-254 (where 0 is the highest priority and 254 is the lowest; lower
order numbers have a higher priority)
Default: If the order keyword is not used, the ACLs have the lowest order
by default (255).
monitor (OPTIONAL) Enter the keyword monitor when the rule is describing the
traffic that you want to monitor and the ACL in which you are creating the rule
will be applied to the monitored interface. For details, see the section
“Flow-based Monitoring” in the Port Monitoring chapter of the FTOS
Configuration Guide.
Version 8.2.1.0 Allows ACL control of fragmented packets for IP (Layer 3) ACLs.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0
Added
monitor option
Version 6.5.10
Expanded to include the optional QoS
order priority for the ACL entry.