Reference Guide

24 | CLI Basics
www.dell.com | support.dell.com
IP COMMUNITY LIST Mode
Use the IP COMMUNITY LIST mode to configure an IP Community ACL on the E-Series. See
Chapter 9, Access Control Lists (ACL).
To enter IP COMMUNITY LIST mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Enter the ip community-list command. You must include a name for the Community list.The
prompt changes to include (config-community-list).
You can return to the CONFIGURATION mode by entering the exit command.
REDIRECT-LIST Mode
Use the REDIRECT-LIST mode to configure a Redirect list on the E-Series, as described in
Chapter 39, Policy-based Routing (PBR).
To enter REDIRECT-LIST mode:
1. Verify that you are logged in to the CONFIGURATION mode.
2. Use the ip redirect-list command. You must include a name for the Redirect-list.The prompt
changes to include (conf-redirect-list).
You can return to the CONFIGURATION mode by entering the exit command.
SPANNING TREE Mode
Use the STP mode to enable and configure the Spanning Tree protocol, as described in Chapter 58,
Spanning Tree Protocol (STP).
To enter STP mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the protocol spanning-tree stp-id command.
You can return to the CONFIGURATION mode by entering the exit command.
Per-VLAN SPANNING TREE Plus Mode
Use PVST+ mode to enable and configure the Per-VLAN Spanning Tree (PVST+) protocol, as
described in Chapter 46, Per-VLAN Spanning Tree plus (PVST+).
To enter PVST+ mode:
1. Verify that you are logged into the CONFIGURATION mode.
2. Enter the protocol spanning-tree pvst command.
You can return to the CONFIGURATION mode by entering the exit command.
Note: The protocol is PVST+, but the plus sign is dropped at the CLI prompt