Reference Guide

Access Control Lists (ACL) | 227
• Use the no deny tcp {source mask | any | host ip-address} {destination mask | any | host
ip-address} command.
Parameters
source
Enter the IP address of the network or host from which the packets were sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when
specified in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host followed by the IP address to specify a host IP
address.
dscp
Enter this keyword to deny a packet based on DSCP value.
Range: 0-63
bit
Enter a flag or combination of bits:
ack: acknowledgement field
fin: finish (no more data from the user)
psh: push function
rst: reset the connection
syn: synchronize sequence numbers
urg: urgent field
operator
(OPTIONAL) Enter one of the following logical operand:
eq = equal to
neq = not equal to
gt = greater than
lt = less than
range = inclusive range of ports (you must specify two ports for the port
command parameter.
port port
Enter the application layer port number. Enter two port numbers if using the
range logical operand.
Range: 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP
• 25 = SMTP
• 169 = SNMP
destination
Enter the IP address of the network or host to which the packets are sent.
mask
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when
specified in A.B.C.D format, may be either contiguous or non-contiguous.
count (OPTIONAL) Enter the keyword count to count packets processed by the
filter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
log (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in
the log. Supported on Jumbo-enabled line cards only.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the
ACL entry.
Range: 0-254 (where 0 is the highest priority and 254 is the lowest; lower
order numbers have a higher priority)
Default: If the order keyword is not used, the ACLs have the lowest order by
default (255).