Reference Guide

210 | Access Control Lists (ACL)
www.dell.com | support.dell.com
show ip access-lists
c e s
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface,
and the count of matches/mismatches against each ACL entry displayed.
Syntax
show ip access-lists [access-list-name] [interface interface] [in |out]
Parameters
Command Modes
EXEC Privilege
Command
History
\
show ip accounting access-list
c e s
Display the IP access-lists created on the switch and the sequence of filters.
Syntax
show ip accounting {access-list access-list-name | cam_count} interface interface
Parameters
access-list-name
Enter the name of a configured MAC ACL, up to 140 characters.
interface interface Enter the keyword interface followed by the one of the following keywords
and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 - 512 for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/
port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
in | out
Identify whether ACL is applied on ingress or egress side.
Version 8.4.1.0 Introduced
access-list-name
Enter the name of the ACL to be displayed.
cam_count
List the count of the CAM rules for this ACL.
interface interface Enter the keyword interface followed by the interface type and slot/port or
number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512
for ExaScale.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.