Reference Guide

802.3ah | 183
ethernet oam remote-loopback (interface)
s
Enable support for OAM loopback on an interface and configure a timeout value.
Syntax
ethernet oam remote-loopback {supported | timeout seconds}
Parameters
Defaults
None
Command Mode
INTERFACE
Command
History
ethernet oam timeout
s
Specify the amount of time that the system waits to receive an OAMPDU from a peer before
considering it non-operational.
Syntax
ethernet oam
timeout value
Parameters
Defaults
5 seconds
Command Mode
INTERFACE
Command
History
show ethernet oam discovery
s
Display the OAM discovery status.
Syntax
show ethernet oam discovery interface interface
Parameters
Defaults
None
Command Mode
EXEC Privilege
Command
History
supported Start or stop a loopback operation on a peer.
timeout
seconds
Specify the number of seconds that the local peer waits to receive a returned frame
before considering a remote peer to be non-operational. Valid values are from 1 to
10.
Version 8.4.1.0 Introduced on S-Series
value
Enter a timeout value in seconds.
Range: 2-30 seconds
Version 8.4.1.0 Introduced on S-Series
interface Enter the interface for which you want to display status, for example gig 0/1.
Version 8.4.1.0 Introduced on S-Series