Reference Guide

182 | 802.3ah
www.dell.com | support.dell.com
Defaults
Active
Command Mode
INTERFACE
Command
History
ethernet oam remote-failure
s
Block or disable an interface when a particular critical link event occurs.
Syntax
ethernet oam remote-failure
{critical-event | dying-gasp | link-fault} action {error-block-interface
| error-disable-interface}
Parameters
Defaults
Disabled
Command Mode
INTERFACE
Command
History
ethernet oam remote-loopback
s
Start or stop loopback operation on a local interface with a remote peer.
Syntax
ethernet oam remote-loopback {start | stop} interface interface
Parameters
Defaults
Enabled
Command Mode
EXEC Privilege
Command
History
Version 8.4.1.0 Introduced on S-Series
critical-event
An unspecified critical event occurred.
dying-gasp An unrecoverable local failure condition occurred.
link-fault A fault occurred in the receive direction of the local peer.
error-block-interface Block the interface if the specified fault occurs.
error-disable-interface Disable the interface if the specified fault occurs.
Version 8.4.1.0 Introduced on S-Series
start | stop
Start or stop a loopback operation with a remote peer.
interface
interface
Specify the interface on which remote-loopback starts/stops, for example
gigabitethernet 0/1.
Version 8.4.1.0 Introduced on S-Series