Reference Guide

180 | 802.3ah
www.dell.com | support.dell.com
Parameters
Defaults
As above
Command Mode
INTERFACE
Command
History
ethernet oam link-monitor high-threshold action
s
Disable an interface when the high threshold is exceeded for any of the monitored error conditions.
Syntax ethernet oam link-monitor high-threshold action error-disable-interface
Defaults
Enabled
Command Mode
INTERFACE
Command
History
ethernet oam link-monitor on
s
Start link performance monitoring on an interface. To stop link monitoring, enter the no ethernet oam
link-monitor on
command.
Link monitoring is started on an interface by default when you enable Ethernet OAM with the ethernet
oam
command.
Syntax ethernet oam link-monitor on
Defaults
Enabled
Command Mode
INTERFACE
Command
History
high
{milliseconds | none} Specify the high threshold value for frame error seconds per time
period, or disable the high threshold.
Range: 1-900
Default: None
low milliseconds Specify the low threshold for frame error seconds per time period.
Range: 1-900
Default: 1
window milliseconds
Specify the time period for error second per time period condition.
Range: 100-900, in multiples of 100
Default: 1000 milliseconds
Version 8.4.1.0 Introduced on S-Series
Version 8.4.1.0 Introduced on S-Series
Version 8.4.1.0 Introduced on S-Series