Reference Guide

S-Series Debugging and Diagnostics | 1585
show hardware stack-unit
s
Display the data plane or management plane input and output statistics of the designated component of
the designated stack member.
Syntax
show hardware stack-unit 0-7 {cpu data-plane statistics [stack-port 0-52] | cpu
party-bus statistics | drops [unit 0-1 [port 0-27]] | stack-port 0-52 | unit 0-1 {counters |
details | port-stats [detail] | register}}
Parameters
Defaults
No default behavior
Command Modes
EXEC
EXEC Privilege
Command
History
stack-unit 0-7
{command-option}
Enter the keyword stack-unit followed by 0 to 7 to select a particular
stack member and then enter one of the following command options
to display a collection of data based on the option entered.
cpu data-plane
statistics
Enter the keywords cpu data-plane statistics, optionally followed by
the keywords
stack port and its number — 0 to 52 — to display the data
plane statistics, which shows the Higig port raw input/output counter
statistics to which the stacking module is connected.
cpu party-bus statistics Enter the keywords cpu party-bus statistics, to display the
Management plane input/output counter statistics of the pseudo party bus
interface.
drops [unit 0-1 [port
0-27]]
Enter the drops keyword to display internal drops on the selected
stack member. Optionally, use the unit keyword with 0 or 1 to select
port-pipe 0 or 1, and then use port 0-27 to select a port on that
port-pipe.
stack-port 0-52 Enter this keyword and a stacking port number to select a stacking
port for which to display statistics. Identify the stack port number as
you would to identify a 10G port that was in the same place in one of
the rear modules.
Note: You can identify stack port numbers by physical inspection of
the rear modules. The numbering is the same as for the 10G ports.
You can also inspect the output of the show system stack-ports
command.
unit 0-1 {counters |
details | port-stats
[detail] | register}
Enter the unit keyword followed by 0 or 1 for port-pipe 0 or 1, and
then enter one of the following keywords to troubleshoot errors on
the selected port-pipe and to give status on why a port is not coming
up to register level: counters, details, port-stats [detail], or
register
Version 7.8.1.0
Modified:
stack-port keyword range expanded from 49-52 to 0-52; output modified
for the
cpu data-plane statistics option; the following options were added:
drops [unit 0-1 [port 0-27]] ; unit 0-1 {counters | details | port-stats
[
detail] | register}
Version 7.7.1.0 Introduced on S-Series