Reference Guide

S-Series Debugging and Diagnostics | 1579
None
Command Mode
BUFFER PROFILE
Usage
Information
If you attempt to apply a buffer profile to a non-existent port-pipe, FTOS displays the following
message. However, the configuration still appears in the running-config.
%DIFFSERV-2-DSA_BUFF_CARVING_INVALID_PORT_SET: Invalid FP port-set 2 for linecard 2.
Valid range of port-set is <0-1>
Usage
Information
When you remove a buffer-profile using the command no buffer-profile [fp | csf] from
CONFIGURATION mode, the buffer-profile name still appears in the output of show buffer-profile
[detail | summary]. After a line card reset, the buffer profile correctly returns to the default values,
but the profile name remains. Remove it from the show buffer-profile [detail | summary]
command output by entering no buffer [fp-uplink | csf] linecard port-set buffer-policy from
CONFIGURATION mode and no buffer-policy from INTERFACE mode.
Command
History
H
Related
Commands
buffer-profile (Configuration)
c s
Create a buffer profile that can be applied to an interface.
Syntax
buffer-profile {{fp | csf} profile-name | global {1Q|4Q}
Parameters
Defaults
global 4Q
Command Mode
CONFIGURATION
linecard slot Enter the keyword linecard followed by the line card slot number.
port-set port-pipe Enter the keyword port-set followed by the port-pipe number.
Range: 0-3 on C-Series, 0-1 on S-Series
buffer-policy
buffer-profile
Enter the keyword buffer-policy followed by the name of a buffer profile
you created.
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
buffer-profile (Configuration) Create a buffer profile that can be applied to an interface.
fp
Enter this keyword to create a buffer profile for the Field Processor.
csf
Enter this keyword to create a buffer profile for the Switch Fabric Processor.
profile-name
Create a name for the buffer profile.
global
Apply one of two pre-defined buffer profiles to all of the port-pipes in the
system.
1Q
Enter this keyword to choose a pre-defined buffer profile for single queue
(i.e non-QoS) applications.
4Q
Enter this keyword to choose a pre-defined buffer profile for four queue (i.e
QoS) applications.