Reference Guide

1560 | E-Series Debugging and Diagnostics
www.dell.com | support.dell.com
Example
Figure 65-16. clear hardware linecard Command Example
Related
Commands
clear hardware rpm mac counters
e
Clear the MAC counters for the party-bus control switch on the IPC subsystem of the RPM.
Syntax
clear hardware rpm slot-number mac counters
Parameters
Defaults
No default behavior or values
Command Mode
EXEC
EXEC Privilege
Command
History
hardware monitor linecard
e
Configure the system to take an action upon a line card hardware error.
Syntax
hardware monitor linecard asic {btm [action-on-error {card-problem | card-reset |
card-shutdown}] | fpc [action-on-error | parity-correction]}
Parameters
FTOS#clear hardware linecard 2 port-set 0 btm ingress errors
FTOS#clear hardware rpm 1 port-set 0 btm ingress errors
FTOS#clear hardware rpm 0 port-set 0 btm ingress errors
% Error: RPM 0 is not active.
FTOS#
show hardware btm Display the BTM counters
slot-number
Enter the RPM slot number.
Range: 0 -1
Version 6.5.4.0 Introduced
action-on-error Enter the keyword action-on-error to further specify actions that should be
taken in the event of a hardware error.
btm Enter the keyword btm to configure the system to take an action upon a Buffer
Traffic Manager hardware error.
fpc Enter the keyword fpc to configure the system to take an action upon a Flexible
Packet Classifier hardware error.
card-problem Enter the keyword card-problem to place a line card in a card-problem state
upon a hardware error.
card-reset Enter the keyword card-reset to reset a line card upon a hardware error.
card-shutdown Enter the keyword card-shutdown to shutdown a line card upon a hardware
error.
parity-correction Enter the keyword parity-correction to enable automatic parity corrections for
SRAM. The line card must be reloaded before the feature becomes operational.