Reference Guide

1548 | E-Series Debugging and Diagnostics
www.dell.com | support.dell.com
Example
Figure 65-8. reset sfm error message
Related
Commands
show diag sfm
e
Display the results and status of the last chassis runtime/onetime loopback test.
Syntax
show diag sfm
Defaults
No default values or behavior
Command Modes
EXEC
Command
History
Example
Figure 65-9. show diag sfm command Example
Note: Resetting an SFM in a power-off state is not permitted. Use the command power-on
sfm
to bring the SFM back to a power-on state.
FTOS#reset sfm 1
% Error: SFM1 is active. Resetting it will impact data traffic.
FTOS#
power-off/on sfm Power on/off an SFM
Version 6.5.4.0 Introduced
FTOS#show diag sfm
Switch Fabric Module Loopback Test: enabled
SFM Walk-Through in Loopback Test: enabled
SFM Bring-Down in Loopback Test: enabled
Switch Fabric Module Loopback State: on
-- Route Processor Modules --
Slot Test Status Last Result Time Stamp
------------------------------------------------------
0 on pass Mar 26 2007 12:41:56
1 off none
-- Line cards --
Slot Test Status Last Result Time Stamp
------------------------------------------------------
0 off none
1 off none
2 on pass Mar 26 2007 12:41:56
3 off none
4 off none
5 off none
6 off none
7 off none
8 off none
9 off none
10 off none
11 on pass Mar 26 2007 12:41:56
12 off none
13 off none
FTOS#