Reference Guide

E-Series Debugging and Diagnostics | 1539
Related
Commands
diag linecard
e
Run a diagnosis on a linecard.
Syntax
diag linecard [slot] [alllevels | level0 | level1 | level2 | terminate]
Parameters
Defaults
Level 0-2
Command Modes
EXEC Privilege
Command
History
Related
Commands
diag sfm
e
Execute a manual dataplane loopback test.
Syntax
diag sfm [all-loopback | rpm-loopback]
Parameters
Defaults
No default behavior or value
Command Modes
EXEC Privilege
Command
History
Usage
Information
If the RPM-SFM or line card-SFM loopback test detects an SFM failure, an attempt is made to isolate
a single faulty SFM by automatically walking the SFMs. For this failure case, error messages similar to
the runtime loopback test error are generated.
diag sfm Initiate a manual dataplane loopback test.
show diag sfm Display the loopback test results
Note: This command is not supported on the E600i chassis.
slot
Enter the slot number of the card you with to diagnose.
alllevels | level0 |
level1 | level2 |
(OPTIONAL) Enter the level of diagnostic desired.
terminate Enter the keyword terminate to stop the test
Version 6.5.4.0 Introduced
reset linecard Reset the line card and bring it back online.
all-loopback (OPTIONAL) Enter the keyword all-loopback to execute a dataplane
loopback test from the RPMs and all line cards.
rpm-loopback (OPTIONAL) Enter the keyword rpm-loopback to execute a dataplane
loopback test on the RPMs only.
Version 6.5.4.0 Introduced