Reference Guide

1538 | E-Series Debugging and Diagnostics
www.dell.com | support.dell.com
dataplane-diag disable sfm-walk
e
Disable the automatic SFM walk that is launched after an RPM-SFM runtime loopback test failure.
Syntax
dataplane-diag disable sfm-walk
To re-enable the automatic SFM walk, use the no dataplane-diag disable sfm-walk command.
Defaults
Enabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
If a full set of SFMs are online during the runtime loopback test and a failure occurs, an automatic
SFM walk is launched in an attempt to determine if the failure is due to a faulty SFM. This command
disables the automatic SFM walk.
Related
Commands
dataplane-diag disable dfo-reporting
e
Disable the per-channel DFO (deskew FIFO overflow) reporting via event logging.
Syntax
dataplane-diag disable dfo-reporting
To re-enable, use the no dataplane-diag disable dfo-reporting command.
Defaults
Enabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
The per-channel DFO error reporting via event logging is enabled by default on TeraScale chassis. The
error reporting issues a warning when a temporary dataplane glitch occurs or when a persistent
malfunction is detected.
When a DFO error is detected, no automatic action is initiated by the system. The message issued is
similar to:
%RPM1-P:CP %CHMGR-2-SFM_PCDFO: PCDFO error detected for SFM4
This command disables the per-channel DFO reporting.
dataplane-diag disable sfm-walk Diable the automatic SFM walk
show diag sfm Display the loopback test results
Version 6.5.4.0 Introduced
dataplane-diag disable loopback Disable the runtime dataplane loopback test
dataplane-diag disable sfm-bringdown Disable the automatic SFM bringdown.
show diag sfm Display the loopback test results
Version 6.5.4.0 Introduced