Reference Guide

1528 | C-Series Diagnostics and Debugging
www.dell.com | support.dell.com
Example
Figure 64-18. show hardware linecard (C-Series Command Example)
Usage
Information
If the command is executed on a non-POE line card, the following error message is generated:
FTOS#sh hardware linecard 6 poe-status
% Error: POE is not supported for this card.
Related
Commands
Buffer Tuning Commands
The buffer tuning commands are:
• buffer (Buffer Profile)
• buffer (Configuration)
• buffer-profile (Configuration)
• buffer-profile (Interface)
• show buffer-profile
• show buffer-profile interface
buffer (Buffer Profile)
c s
Allocate an amount of dedicated buffer space, dynamic buffer space, or packet pointers to queues 0 to
3.
Syntax
buffer [dedicated | dynamic | packet-pointers] queue0 number queue1 number queue2
number queue3 number
Parameters
FTOS#show hardware linecard 7 poe-status
HW Status for POE Controller 0
The HW Status is
----------------
The Internal address is - 0x0000
The I2C address is - 0x003c
Is Master - Yes
The I2C Mode is - I2C
The mode is configured properly
The address is configured properly
The Controller and I2C is configured properly
FTOS#
show power supply Display the power supply status.
Warning: Altering the buffer allocations is a sensitive operation. Do not use any
buffer tuning commands without first contacting the Dell Force10 Technical
Assistance Center.
dedicated
Enter this keyword to configure the amount of dedicated buffer space per
queue.
dynamic
Enter this keyword to configure the amount of dynamic buffer space per
Field Processor.
packet-pointers
Enter this keyword to configure the number of packet pointers per queue.