Reference Guide

1518 | C-Series Diagnostics and Debugging
www.dell.com | support.dell.com
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
History
Usage
Information
Layer 2 Debug Command
show software macagent
c
This command displays tables and advanced debugging information related to the MAC Agent
process.
Syntax
show software macagent {configs | mac-addr-table {dump | count} | port interface
interface | port-channel number | stg number | vlan number} line-card number
Parameters
interface
Enter one of the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For Loopback interfaces, enter the keyword
loopback followed by a
number from 0 to 16383.
• For the management interface on the RPM, enter the keyword
ManagementEthernet followed by the slot/port information. The slot
range is 0-1 and the port range is 0.
• For the Null interface, enter the keywords
null 0.
• For a Port Channel interface, enter the keyword
port-channel followed
by a number:
C-Series Range: 1-128
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
number
Enter the linecard slot number.
Range: 0-7 for the C300
Version 4.2.1.0 Introduction
Warning: Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
configs The keyword configs shows the initial configurations of the MAC Agent.
mac-addr-table The keyword mac-addr-table shows the number of MAC addresses in the MAC
Agent software.
dump The keyword dump shows the MAC addresses present in the software.
count The keyword count shows the number of MAC addresses present in the software.