Reference Guide

C-Series Diagnostics and Debugging | 1517
debug ifm trace-flags
c
Turn on IFM internal trace-flags.
Syntax
debug ifm trace-flags trace-flag
Disable this command using the no debug ifm trace-flags command.
Parameters
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
History
Usage
Information
Turning on a trace flag does not result in an output to the console/terminal. It prints trace information
to the trace buffer, which is viewed using the show trace history command.
show software ifm
c
View interface management information.
Syntax
show software ifm {clients [summary] | ifagt number | ifcb interface | linecard number |
trace-flags}
Parameters
trace-flag
Enter a hexadecimal number representing the trace-flag.
Version 4.2.1.0 Introduction
Warning: Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
clients (OPTIONAL) Enter the keyword clients to view information on IFM clients.
summary (OPTIONAL) Enter the keyword summary to view show brief information
of IFM clients.
ifagt Enter the keyword ifagt to view software pipe and IPC statistics for IFAGT.
ifcb Enter the keyword ifcb to view information about the Interface Control Block.
linecard Enter the keyword linecard view interface management information for line
cards.
trace-flags Enter the keyword trace-flags to view interface management
information for internal trace flags.