Reference Guide

C-Series Diagnostics and Debugging | 1515
Related
Commands
show hardware acl
c
View Layer 2 or Layer 3 access control list entries.
Syntax
show hardware {layer2 | layer 3} acl linecard number port-set number
Parameters
Defaults
None
Command Mode
EXEC
EXEC Privilege
Command
History
Usage
Information
show hardware layer3 qos linecard port-set
c
View Layer 3 QoS messages.
Syntax
show hardware layer3 qos linecard port-set
Parameters
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
History
show hardware system-flow layer2 linecard port-set View system-flow entries.
layer2
Enter the keyword layer2 to view Layer 2 access control list
entries for the specified line card
.
layer3 Enter the keyword layer3 to view Layer 3 access control list
entries for the Forwarding Processor of the specified line card.
number
Enter a number after the following keywords:
• After the keyword
linecard:
Range: 0-7 for the C300; 0–3 for the C150
• After the keyword
port-set, enter the Port-Pipe/FB ID.
Version 4.2.1.0 Introduction
Warning: Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
number
Enter a number after the following keywords:
• After the keyword
linecard:
Range: 0-7 for the C300
• After the keyword
port-set, enter the Port-Pipe/FB ID.
Version 7.5.1.0 Introduction