Reference Guide

1514 | C-Series Diagnostics and Debugging
www.dell.com | support.dell.com
Example
Figure 64-14. show revision Command Example
ACL and System-Flow Debug Commands
• clear hardware system-flow
• show hardware acl
• show hardware layer3 qos linecard port-set
• show hardware system-flow layer2 linecard port-set
clear hardware system-flow
c
Clear system-flow entry counters.
Syntax
clear hardware system-flow layer2 linecard number port-set number counters
Parameters
Defaults
None.
Command Mode
EXEC
EXEC Privilege
Command
History
Usage
Information
FTOS#show revision
-- RPM 0 --
C300 RPM FPGA : 3.8
Required FPGA version : 3.8
-- Secondary RPM --
C300 RPM FPGA : 3.8
Required FPGA version : 3.8
-- Line card 3 --
48 Port 1G LCM FPGA : 2.6
Required FPGA version : 2.6
-- Line card 7 --
48 Port 1G LCM FPGA : 2.6
Required FPGA version : 2.6
FTOS#
number
Enter a number after the following keywords:
• After the keyword
linecard:
Range: 0-7 for the C300
• After the keyword
port-set, enter the Port-Pipe/FB ID.
Version 4.2.1.0 Introduction
Warning: Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.