Reference Guide

C-Series Diagnostics and Debugging | 1505
Figure 64-7. show hardware drops unit port Command Example
Usage
Information
show hardware cpu data-plane
c
View the driver statistics on the CPU of the specified line card or RPM.
Syntax
show hardware {linecard | rpm} number cpu data-plane statistics
Parameters
Defaults
None
Command Mode
EXEC
EXEC Privilege
Command
History
FTOS#show hardware rpm 0 drops unit 0 port 1
--- Ingress Drops ---
Unknown HiGig HDR :0
Unknown HiGig OPCODE :0
Unknown HiGig HDR Format :0
RX EgressBlockMask :0
Rx LinkBlockCntr :0
Rx SrcModBlockCntr :0
IBP CBP FullDrops :0
Rx AgedCounter :0
--- Ingress MAC Drops ---
IngressMacDrops :0
--- MMU Drops ---
HOL DROPS on COS0 :0
HOL DROPS on COS1 :0
HOL DROPS on COS2 :0
HOL DROPS on COS3 :0
HOL DROPS on COS4 :0
HOL DROPS on COS5 :0
HOL DROPS on COS6 :0
HOL DROPS on COS7 :0
--- Egress MAC counters ---
egressMACDrops :0
--- Egress Drops ---
Tx AgedCounter :0
Tx ErrCounter :0
Tx MacUnderFlow :0
Warning: Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
linecard Enter the keyword linecard to view cpu data plane statistics for a
line card.
rpm Enter the keyword rpm to view cpu data plane statistics for an
RPM.
number
Enter a number after the following keywords:
• After the keyword
rpm:
Range: 0-1
• After the keyword
linecard:
Range: 0-7 for the C300
Version 7.5.1.0 Introduction