Reference Guide

C-Series Diagnostics and Debugging | 1499
Example
Figure 64-1. show hardware linecard Command Example
Usage
Information
Related
Commands
show hardware rpm mac
c
View receive and transmit counters for the party-bus switch in the IPC subsystem.
Syntax
show hardware rpm number mac {counters | port-statistics {linecard number | rpm
number}}
Parameters
Defaults
None
Command Mode
EXEC
EXEC Privilege
FTOS#show hardware linecard 1 cpu party-bus statistic
ACTIVE EMAC DEVICE:2 STATISTICS
Num of Pkts. Tx Requested = 2788452, Number of Pkts Transmitted = 2788452
Num of Pkts. Received = 139662, Number of Pkts Given to MUX = 139662
Transmit Errors due to no Data = 0
Transmit Errors due to exceed num of Desc = 0
Transmit Block Count (Stall Count) = 0
Recv Pkts Dropped due to Bad Pkts Rx = 0
Recv Pkts Dropped due to more than one Buf = 0
Recv Pkts Dropped due to out of Mem = 0
Recv Pkts Dropped due to out of CBlk = 0
Recv Pkts Dropped due to out of MBlk = 0
ALTERNATIVE EMAC DEVICE:3 STATISTICS
Num of Pkts. Tx Requested = 0, Number of Pkts Transmitted = 0
Num of Pkts. Received = 0, Number of Pkts Given to MUX = 0
Transmit Errors due to no Data = 0
Transmit Errors due to exceed num of Desc = 0
Transmit Block Count (Stall Count) = 0
Recv Pkts Dropped due to Bad Pkts Rx = 0
Recv Pkts Dropped due to more than one Buf = 0
Recv Pkts Dropped due to out of Mem = 0
Recv Pkts Dropped due to out of CBlk = 0
Recv Pkts Dropped due to out of MBlk = 0
value = 0 = 0x0
Warning: Use this command only when you are working directly with a technical
support representative to troubleshoot a problem. Do not use this command
unless a technical support representative instructs you to do so.
clear hardware cpu party-bus Clear the receive, transmit, and error counters and for the party-bus port
on the CPU of the specified RPM.
counters Enter the keyword counters to view high-level receive and transmit counters.
port-statistics Enter the keyword port-statistics to view detailed Ethernet statistics for the
specified port on the party-bus switch.
linecard Enter the keyword linecard to view information about a particular line card.
rpm Enter the keyword rpm to view information about a particular RPM.
number
Enter a number after the following keywords:
• After the keyword
rpm:
Range: 0-1
• After the keyword
linecard:
Range: 0-7 for the C300