Reference Guide

1490 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
debug vrrp ipv6
e c s
Allows you to enable debugging of VRRP.
Syntax
debug vrrp ipv6 interface [vrid] {all | packets | state | timer}
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by
the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
E-Series Range: 1 to 255 for TeraScale
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by the VLAN ID. The VLAN
ID range is from 1 to 4094.
vrid
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all Enter the keyword all to enable debugging of all VRRP groups.
bfd Enter the keyword bfd to enable debugging of all VFFP BFD interactions
database
Enter the keyword database to display changes related to group, prefix, and interface
entries in the VRRP table.
packets Enter the keyword packets to enable debugging of VRRP control packets.
state Enter the keyword state to enable debugging of VRRP state changes.
timer Enter the keyword timer to enable debugging of the VRRP timer.
Version 8.4.1.0 Introduced on E-Series ExaScale, C-Series, and S-Series.
Version 8.3.2.0 Introduced on E-Series TeraScale