Reference Guide

1478 | Virtual Router Redundancy Protocol (VRRP)
www.dell.com | support.dell.com
Usage
Information
If no options are specified, debug is active on all interfaces and all VRRP groups.
description
c e s
Configure a short text string describing the VRRP group.
Syntax
description text
Parameters
Defaults
Not enabled.
Command Modes
VRRP
Command
History
disable
c e s
Disable a VRRP group.
Syntax
disable
Defaults
C and S-Series default: VRRP is enabled.
E-Series default: VRRP is disabled.
Command Modes
VRRP
Command
History
Usage
Information
To enable VRRP traffic, assign an IP address to the VRRP group using the virtual-address command
and enter no disable.
Related
Commands
text
Enter a text string up to 80 characters long.
Version 8.3.2.0 Introduced for IPv6 on E-Series TeraScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
Version 8.3.2.0 Introduced for IPv6 on E-Series TeraScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
virtual-address Specify the IP address of the Virtual Router.