Reference Guide

Virtual Router Redundancy Protocol (VRRP) | 1477
clear counters vrrp
c e s
Clear the counters recorded for IPv4 VRRP operations.
Syntax
clear counters vrrp [vrid | vrf instance]
Parameters
Command Modes
EXEC Privilege
Command
History
debug vrrp
c e
Allows you to enable debugging of IPv4 VRRP.
Syntax
debug vrrp interface [vrid] {all | packets | state | timer}
Parameters
Command Modes
EXEC Privilege
Command
History
vrid
(OPTIONAL) Enter the number of the VRRP group ID.
Range: 1 to 255
vrf instance
(OPTIONAL) E-Series only: Enter the name of a VRF instance (32 characters maximum)
to clear the counters of all VRRP groups in the specified VRF.
Version 8.4.1.0
Support was added for VRRP groups in non-default VRF instances.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by
the slot/port information.
• For a Port Channel interface, enter the keyword port-channel followed by a number:
C-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for
ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a VLAN interface, enter the keyword
vlan followed by the VLAN ID. The VLAN
ID range is from 1 to 4094.
vrid
(OPTIONAL) Enter a number from 1 to 255 as the VRRP group ID.
all
Enter the keyword all to enable debugging of all VRRP groups.
bfd
Enter the keyword bfd to enable debugging of all VFFP BFD interactions
packets
Enter the keyword packets to enable debugging of VRRP control packets.
state
Enter the keyword state to enable debugging of VRRP state changes.
timer
Enter the keyword timer to enable debugging of the VRRP timer.
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series