Reference Guide

ManualsBrandsDell ManualsNetworkingForce10 S25-01-GE-24P

1461

Virtual Routing and Forwarding (VRF) | 1469

cam-profile ipv4-vrf

(E-Series Exascale only) Set the VRF CAM profile for IPv4 only.

Syntax

cam-profile ipv4-vrf microcode ipv4-vrf

Command Modes

CONFIGURATION

Command

History

Example

Usage

Information

Reload the system after entering this command to activate this CAM profile.

Do not use this command in EXEC Privilege mode.

Commands

Version 8.2.1.0 Introduced on the E-Series

FTOS(conf)#cam-profile ipv4-vrf microcode ipv4-vrf

FTOS(conf)#do reload

-- Chassis CAM Profile --

CamSize : 18-Meg

: Current Settings : Next Boot

Profile Name : ipv4-vrf : ipv4-vrf

L2FIB : 32K entries : 32K entries

L2ACL : 3K entries : 3K entries

IPv4FIB : 160K entries : 160K entries

IPv4ACL : 2K entries : 2K entries

IPv4Flow : 12K entries : 12K entries

EgL2ACL : 1K entries : 1K entries

EgIPv4ACL : 12K entries : 12K entries

Reserved : 2K entries : 2K entries

IPv6FIB : 0 entries : 0 entries

IPv6ACL : 0 entries : 0 entries

IPv6Flow : 0 entries : 0 entries

EgIPv6ACL : 0 entries : 0 entries

MicroCode Name : Ipv4-Vrf : Ipv4-Vrf

-- Line card 1 - per Port Pipe --