Reference Guide

VLAN Stacking | 1457
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
dei mark
c s
Set the DEI value on egress according to the color currently assigned to the packet.
Syntax
dei mark {green | yellow} {0 | 1}
Parameters
Defaults
All the packets on egress will be marked with DEI 0.
Command Mode
INTERFACE
Command
History
Usage
Information
You must first enable DEI for this configuration to take effect.
Related
Commands
member
c e s
Assign a Stackable VLAN access or trunk port to a VLAN. The VLAN must contain the vlan-stack
compatible command in its configuration.
Syntax
member interface
To remove an interface from a Stackable VLAN, use the no member interface command.
Parameters
Defaults
Not configured.
Command Mode
CONF-IF-VLAN
dei enable
0 | 1 Enter the bit value you want to map to a color.
green |
yellow
Choose a color:
• Green: High priority packets that are the least preferred to be dropped.
• Yellow: Lower priority packets that are treated as best-effort.
Version 8.3.1.0 Introduced on C-Series and S-Series.
dei enable
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the
slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 32 for EtherScale, 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed
by the slot/port information.