Reference Guide

1422 | Spanning Tree Protocol (STP)
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
Command
History
Example
Figure 58-1. protocol spanning-tree Command Example
Usage
Information
STP is not enabled when you enter the SPANNING TREE mode. To enable STP globally on the
switch, enter no disable from the SPANNING TREE mode.
Related
Commands
show config
c e s
Display the current configuration for the mode. Only non-default values are displayed.
Syntax
show config
Command Modes
SPANNING TREE
Command
History
Example
Figure 58-2. show config Command for the SPANNING TREE Mode
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
FTOS(conf)#protocol spanning-tree 0
FTOS(config-stp)#
disable
Disable Spanning Tree group 0. To enable Spanning Tree group 0, enter
no disable.
Version 7.7.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
FTOS(config-stp)#show config
protocol spanning-tree 0
no disable
FTOS(config-stp)#