Reference Guide

1408 | S-Series Stacking Commands
www.dell.com | support.dell.com
Example
Figure 56-6. stack-unit renumber Command Example
Related
Commands
upgrade system stack-unit (S-Series stack member)
s
Copy the boot image or FTOS from the management unit to one or more stack members.
Syntax
upgrade {boot | system} stack-unit {all | 0-7}
Parameters
Defaults
No configuration or default values
Command Modes
EXEC
Command
History
Usage
Information
You must reload FTOS after using the upgrade command.
Related
Commands
S50V_7.7#stack-unit 0 renumber 2
Renumbering master unit will reload the stack. Proceed to renumber [confirm yes/
no]:
reload Reboot FTOS.
reset stack-unit Reset the designated S-Series stack member.
show system (S-Series) Display the current status of all stack members or a specific member.
boot
Enter this keyword to copy the boot image from the management unit to the
designated stack members.
system
Enter this keyword to copy the FTOS image from the management unit to the
designated stack members.
all
Enter this keyword to copy the designated image to all stack members.
0-7
Enter the unit ID of the stack member to which to copy the designated image.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
reset stack-unit Reset the designated S-Series stack member.
show system (S-Series) Display the current status of all stack members or a specific member.
show version Display the current FTOS version information on the system.
upgrade (S-Series management
unit)
Upgrade the bootflash image or system image of the S-Series management
unit.