Reference Guide

S-Series Stacking Commands | 1407
stack-unit provision
s
Pre-configure a logical stacking ID of a switch that will join the stack. This is an optional command
that is executed on the management unit.
Syntax
stack-unit 0-7 provision {S25N|S25P|S25V|S50N|S50V}
Parameters
Defaults
When this value is not set, a switch joining the stack is given the next available sequential stack
member identifier.
Command Modes
CONFIGURATION
Command
History
Related
Commands
stack-unit renumber
s
Change the stack member ID of any stack member or a stand-alone S-Series.
Syntax
stack-unit 0-7 renumber 0-7
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are renumbered,
only that specific unit will reset and come up with the new unit number.
0-7
Enter a stack member identifier, from 0 to 7, of the switch that you want to add to the
stack.
S25N|S25P|S25V||
S50N|S50V
Enter the S-Series model identifier of the switch to be added as a stack member. This
identifier is also referred to as the provision type.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series) Display the current status of all stack members or a specific member.
0-7
The first instance of this value is the stack member unit identifier, from 0 to 7, of the
switch that you want add to the stack.
The second instance of this value is the desired new unit identifier number.
Version 7.7.1.0 Introduced on S-Series