Reference Guide

1406 | S-Series Stacking Commands
www.dell.com | support.dell.com
Related
Commands
stack-unit priority
s
Configure the ability of an S-Series switch to become the management unit of a stack.
Syntax
stack-unit 0-7 priority 1-14
Parameters
Defaults
1
Command Modes
CONFIGURATION
Command
History
Related
Commands
Link Speed Link Speed of the stack port (12 or 24) in Gb/s
Admin
Status
The only currently listed status is Up.
Connection The stack port ID to which this unit’s stack port is connected
Table 56-1. show interfaces description Command Example Fields
Field Description
reset stack-unit Reset the designated S-Series stack member.
show hardware stack-unit Display the data plane or management plane input and output statistics of the
designated component of the designated stack member.
show system (S-Series) Display the current status of all stack members or a specific member.
upgrade (S-Series
management unit)
Upgrade the bootflash image or system image of the S-Series management
unit.
0-7
Enter the stack member unit identifier, from 0 to 7, of the switch on which you want to set the
management priority.
1-14
This preference parameter allows you to specify the management priority of one backup switch
over another, with 0 the lowest priority and 14 the highest.
The switch with the highest priority value will be chosen to become the management unit if the
active management unit fails or on the next reload.
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series) Display the current status of all stack members or a specific member.