Reference Guide

SONET | 1399
Related
Commands
sonet-port-recover detection-interval
e
Recovery interval to automatically clear a condition that could cause a SONET port to hang, and stop
sending and receiving data.
Syntax
sonet-port-recover detection-interval interval
Parameters
Defaults
60 seconds
Command Modes
INTERFACE
Privilege Level
15 sys-hidden
IPCP State: States if IPCP was successfully negotiated.
Internet address... States whether an IP address is assigned to the interface. If one is, that address
is displayed.
Peer address Displays the PPP peer’s IP address.
MTU 1554... Displays link and IP MTU.
LineSpeed Displays interface’s line speed.
ARP type:... Displays the ARP type and the ARP timeout value for the interface.
Last clearing...
Displays the time when the
show interfaces counters where cleared.
Queuing strategy. States the packet queuing strategy. FIFO means first in first out.
0 packets... Displays the number of packets and bytes into the interface.
Input 0 IP packets... Displays the number of packets with IP headers, VLAN tagged headers and
MPLS headers.
The number of packets may not add correctly because a VLAN tagged IP
packet counts as both a VLAN packet and an IP packet.
0 64-byte... Displays the size of packets and the number of those packets entering that
interface.
This information is displayed over 2 lines.
Any PPP packet less than 64 bytes in length will be padded out to 64 bytes
upon reception. This padding will be counted by the ingress byte counter.
Received 0... Displays the type and number of error or other specific packets received.
This information is displayed over 3 lines.
Output 0... Displays the type and number of packets sent out the interface.
This information is displayed over 2 lines.
Time since... Displays the time since the last change in the configuration of this interface.
Table 55-3. Fields in the show interfaces sonet with PPP Encapsulation (continued)
Field Description
show interfaces switchport Displays Layer 2 information about the interfaces.
show ip interface Displays Layer 3 information about the interfaces.
interval Interval for SONET port recovery (in seconds(15-600)