Reference Guide

1388 | SONET
www.dell.com | support.dell.com
Parameters
Defaults
as above
Command Modes
INTERFACE
Usage
Information
You enter the flag C2 and J0 values in decimal, but the FTOS displays the values in hexidecimal in the
show controllers sonet command output.
framing
e
Set the type of framing used on a POS/SDH interface.
Syntax
framing {sdh | sonet}
To return to the default, enter no framing.
Parameters
Defaults
sonet
Command Modes
INTERFACE
Usage
Information
Framing should be changed only when the interfaces are shutdown.
hardware monitor mac action-on-error port-shutdown
e
Shut down and bring back up the port (flap).
Syntax
hardware monitor mac action-on-error port-shutdown
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
c2 value Enter the keyword c2 followed by value to set the path signal byte.
Range: 0x00 to 0xFF hexadecimal (0-255 decimal)
Default: 0xCF in hexidecimal (207 in decimal)
j0 value Enter the keyword j0 to set the section trace byte.
Range: 0x00 to 0xFF hexadecimal (0-255 decimal)
Default: 0xCC (204 in decimal)
sdh Enter the keyword sdh to specify Synchronous Digital Hierarchy (SDH) framing.
Default: Sonet
sonet Enter the keyword sonet to specify SONET framing.
Default: Sonet
Version 7.7.1.0 Introduced command