Reference Guide

1386 | SONET
www.dell.com | support.dell.com
Parameters
Command Modes
EXEC Privilege
Usage
Information
If you enter debug ppp without parameters, all parameters are enabled.
delay triggers
e
Delay triggering the line or path alarms with a 100ms delay.
Syntax
delay triggers {line [lrdi | sd-ber | sf-ber] | path [pais | prdi]}
To disable delay trigger (the default), enter no delay triggers {line [lrdi | sd-ber | sf-ber] | path
[pais | prdi]} command.
Parameters
Defaults
Disabled
Command Modes
INTERFACE
Command
History
Usage
Information
By default, certain alarms (LOS, LOF, LAIS, PLOP) bring the line protocol down immediately. Use
this command, with the line option, to delay that trigger event by 100ms.
By default, path alarms (AIS, RDI, LOP) do not cause (or trigger) the interface line protocol to go
down. This command, with the path option, can be used to trigger this action with a delay of 100ms.
authentication (OPTIONAL) Enter the keyword authentication to display PPP authentication
exchanges (Challenge Authentication Protocol (CHAP) packet exchanges and
Password Authentication Protocol (PAP) exchanges) and traffic.
error (OPTIONAL) Enter the keyword error to display PPP error statistics and protocol
errors.
negotiation (OPTIONAL) Enter the keyword negotiation to display PPP settings negotiated
at startup.
packet (OPTIONAL) Enter the keyword packet to display low-level packet dumps.
interface sonet
slot/port
Enter the keywords interface sonet followed by the slot and port information.
line Enter the keyword line to delay the specified line alarm.
lrdi (OPTIONAL) Enter the keyword lrdi to specify line remote defect
indicator.
sd-ber (OPTIONAL) Enter the keyword sd-ber to specify signal degradation
BER errors.
sf-ber (OPTIONAL) Enter the keyword sf-ber to specify signal failure BER
errors.
path Enter the keyword path to delay the specified path alarm.
pais (OPTIONAL) Enter the keyword pais to specify path alarm indication
signal.
prdi (OPTIONAL) Enter the keyword prdi to specify the path remote defect
indication.
Version 7.4.2.0 Added path option