Reference Guide

1384 | SONET
www.dell.com | support.dell.com
• show interfaces
• sonet-port-recover detection-interval
• speed
ais-shut
e
Enable an alarm indication signal (AIS) when the SONET interface is shutdown.
Syntax
ais-shut
To disable the AIS, enter no ais-shut.
Defaults
Disabled.
Command Modes
INTERFACE
alarm-report
e
Specify which POS/SDH alarms to report to the remote SNMP server.
Syntax
alarm-report {lais | lrdi | pais | plop | prdi | sd-ber | sf-ber | slof | slos}
To disable an alarm, use the no alarm-report {lais | lrdi | pais | plop | prdi | sd-ber | sf-ber | slof
| slos} command.
Parameters
Defaults
Disabled—no alarm reporting for all alarms
Command Modes
INTERFACE
Usage
Information
Alarm reporting is available with this command. SNMP traps are available; however, syslogs are not
generated. To display active alarms and defects, use the show controllers command. The table below
defines the alarms that can be enabled by this command. If enabled for reporting, the alarms will
generate reports on a trap receiver.
lais Enter the keyword lais to report line alarm indication signal.
lrdi Enter the keyword lrdi to report line remote defect indicator.
pais Enter the keyword pais to report path alarm indication signal.
plop Enter the keyword plop to report path loss of pointer.
prdi Enter the keyword prdi to report the path remote defect indication.
sd-ber Enter the keyword sd-ber to report signal degradation BER errors.
sf-ber Enter the keyword sf-ber to report signal failure BER errors.
slof Enter the keyword slof to report section loss of frame.
slos Enter the keyword slos to report section loss of signal.