Reference Guide

1376 | SNMP and Syslog
www.dell.com | support.dell.com
Command
History
Related
Commands
logging history
c e s
Specify which messages are logged to the history table of the switch and the SNMP network
management station (if configured).
Syntax
logging history level
To return to the default values, enter no logging history.
Parameters
Defaults
4 or warnings
Command Modes
CONFIGURATION
Command
History
Usage
Information
When you configure the snmp-server trap-source command, the system messages logged to the history
table are also sent to the SNMP network management station.
Related
Commands
logging history size
c e s
Specify the number of messages stored in the FTOS logging history table.
Syntax
logging history size size
To return to the default values, enter no logging history size.
Parameters
Defaults
1 message
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging Enable logging to a Syslog server.
logging on Enables logging.
level
Indicate a value from 0 to 7 or enter one of the following equivalent words:
emergencies, alerts, critical, errors, warnings, notifications, informational, or
debugging.
The default is 4.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
show logging history Display information logged to the history buffer.
size
Indicate a value as the number of messages to be stored.
Range: 0 to 500.
Default: 1 message.