Reference Guide

SNMP and Syslog | 1373
Related
Commands
default logging trap
c e s
Return to the default settings for logging messages to the Syslog servers.
Syntax
default logging trap
Defaults
level = 6 or informational
Command Modes
CONFIGURATION
Command
History
Related
Commands
logging
c e s
Configure an IP address or host name of a Syslog server where logging messages will be sent. Multiple
logging servers of both IPv4 and/or IPv6 can be configured.
Syntax
logging {ipv4-address | ipv6-address | hostname}
To disable logging, enter no logging.
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Related
Commands
logging monitor Set the logging monitor parameters.
terminal monitor Send system messages to the terminal/monitor.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging trap Limit messages logged to the Syslog servers based on severity.
ipv4-address |
ipv6-address
Enter an IPv4 address (A.B.C.D) or IPv6 address (X:X:X:X::X) address.
hostname
Enter the name of a host already configured and recognized by the switch.
Version 8.4.1.0 Added support for IPv6.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging on Enables the logging asynchronously to logging buffer, console, Syslog server, and
terminal lines.
logging trap Enables logging to the Syslog server based on severity.