Reference Guide

SNMP and Syslog | 1367
snmp-server packetsize
c e s
Set the largest SNMP packet size permitted when the SNMP server is receiving a request or generating
a reply, use the snmp-server packetsize global configuration command.
Syntax
snmp-server packetsize byte-count
Parameters
Defaults
8
Command Modes
CONFIGURATION
Command
History
snmp-server trap-source
c e s
Configure a specific interface as the source for SNMP traffic.
Syntax
snmp-server trap-source interface
To disable sending traps out a specific interface, enter no snmp trap-source.
Parameter
Defaults
The IP address assigned to the management interface is the default.
Command Modes
CONFIGURATION
Command
History
Usage
Information
For this snmp-server trap-source command to be enabled, you must configure an IP address on the
interface and enable the interface configured as an SNMP trap source.
Related
Commands
byte-count
Enter one of the following values 8, 16, 24 or 32. Packet sizes are 8000 bytes, 16000 bytes,
32000 bytes, and 64000 bytes.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
interface
Enter the following keywords and slot/port or number information:
• For an 100/1000 Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Loopback interface, enter the keyword
loopback followed by a
number from 0 to 16383.
• For a SONET interface, enter the keyword
sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port information.
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
snmp-server community Set the community string.